Pneumatic Oscillating Tool Fseries

Pneumatic Oscillating Tool Fseries

Pneumatic Oscillating Tool Fseries

Enviando, espera por favor...

¡Tu pregunta ha sido enviada! Te contestaremos tan pronto como sea posible.

¡Lo siento! Ha ocurrido un error enviando tu pregunta.

500-9350

New product

3 985,00 €

The pneumatic oscillating tool is capable of cutting materials up to 25mm thick. It is suitable for cutting thick materials like honeycomb board, corrugated cardboard and foam boards, as well as some soft foams and rubbers.

General Info

The pneumatic oscillating tool (POT), powered by compressed air, moves the knife up and down over a stroke of 8mm with a maximum frequency of 150Hz. Materials up to 25mm thick can be cut. The robust construction of the tool makes it suitable for cutting thicker materials like honeycomb board, corrugated cardboard and foam boards. By adjusting the knife speeds, some soft foams and rubbers can also be cut.

Includes:

  • Pneumatic Oscillator with Gliding Disk
  • 1 Knife (20 x 0.65mm) with hex key
  • Pneumatic Kit, including Pneumatic Oil and Oil Mister
  • Installation Guide and Collar Wrench

 
Note: Air-compressor not included.


 
Specifications

Stroke: 8mm*
Frequency: 150Hz*
Compressed Air Requirements: 6bar & 78l/min.
It is advised that the compressor have 4-5 times the airflow capacity:
+/- 360l/min

* The Stroke and Frequency may drop depending on the load on the tool.

This tool can be used with the following materials:
 

Cardboard:

Corrugated C Flute (4mm)
Corrugated BC Flute (7mm)
Honeycomb Board <= 10mm
Honeycomb Board >= 10mm
Reboard 10mm
Reboard >= 10mm
 

Synthetic Materials:

Corrugated Plastic > 5mm
 

Composite Sandwich Board:

Foamboard with Paper > 5mm
Foamboard with Plastic
Foamboard with Aluminum
 

Special Materials:

Foam

No customer questions for the moment.

Ask a question
Your Question has been successfully sent our team. Thanks for question!

Pneumatic Oscillating Tool Fseries

3 985,00 €
Añadir a la cesta
Please wait...